Nissan Murano: Towing a trailer / Flat towing for all–wheel drive vehicle (if so equipped)

Nissan Murano (Z52) 2015-2024 Owners Manual / Technical and consumer information / Towing a trailer / Flat towing for all–wheel drive vehicle (if so equipped)

Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home.

CAUTION

Failure to follow these guidelines can result in severe transmission damage.
Never flat tow your All-Wheel Drive (AWD) vehicle.
DO NOT tow your All-Wheel Drive (AWD) vehicle with any wheels on the ground. Doing so may cause serious and expensive damage to the powertrain.
For emergency towing procedures refer to “Towing recommended by NISSAN” in the “In case of emergency” section of this manual.

Trailer towing tips

In order to gain skill and an understanding of the vehicle’s behavior, you should practice turning, stopping and backing up in an area which is free from traffic...

Flat towing for front wheel drive vehicle (if so equipped)

Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Meter Control Switch Signal Circuit

Diagnosis Procedure CHECK METER CONTROL SWITCH SIGNAL Ignition switch ON. Check voltage between the following terminals of the meter control switch harness connector. Meter control switch Condition Voltage (Approx.) Connector Terminals (+) (−) M27 7 4 When illumination control switch (−) is pressed 0 V Other than the above 5 V 5 When trip reset switch is pressed 0 V Other than the above 5 V 6 When illumination control switch (+) is pressed 0 V Other than the above 5 V Is the inspection result normal? YES>> Inspection End...

Nissan Murano (Z52) 2015-2024 Service Manual: Starting System :: Removal and Installation. Starter Motor

Exploded View 1. Cylinder block 2. Shim 3. Starter 4. "B" terminal harness 5. "S" connector Removal and Installation NOTE: When removing components such as hoses, tubes/ lines, etc., cap or plug openings to prevent fluid from spilling...