Nissan Murano: Basic Inspection / Diagnosis and Repair Workflow
OVERALL SEQUENCE
DETAILED FLOW
GET INFORMATION FOR SYMPTOM
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred).
>>
GO TO 2.
CONFIRM THE SYMPTOM
Try to confirm the symptom described by the customer. Verify relation between the symptom and the condition when the symptom is detected.
>>
GO TO 3.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
-
Ignition switch ON and wait for 2 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
Are any DTCs displayed?
YES>>Refer to DTC Index.
NO>>GO TO 4.
PERFORM SYMPTOM DIAGNOSIS
Refer to Symptom Table.
>>
GO TO 5.
FINAL CHECK
Refer to symptom described by the customer in step 1.
Is the symptom still present?
YES>>GO TO 2.
NO>>Inspection End.
Additional Service When Replacing Av Control Unit
Description
BEFORE REPLACEMENTWhen replacing AV control unit, save or print current vehicle specification with CONSULT configuration before replacement...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: C1a03 Vehicle Speed Sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1A03–64 VHCL SPEED SE CIRC (Nissan Murano Vehicle speed sensor circuit) Diagnosis condition When ignition switch in ON. Signal (terminal) — Threshold If the Nissan Murano vehicle speed signal (wheel speed) from ABS actuator and electric unit (control unit) and the CVT vehicle speed sensor signal (output shaft revolution signal) from TCM, received by the distance sensor (ICC sensor) via CAN communication, are inconsistent If tire size is not correct Diagnosis delay time — POSSIBLE CAUSE Wheel speed sensor ABS actuator and electric unit (control unit) Nissan Murano Vehicle speed sensor CVT (output speed sensor) TCM Distance sensor (ICC sensor) Tire FAIL-SAFEThe following systems are canceled: Intelligent Cruise Control (ICC) Automatic Emergency Braking (AEB) Intelligent Forward Collision Warning (I-FCW) Blind Spot Warning (BSW) DTC Confirmation Procedure CHECK DTC PRIORITY If DTC “C1A03–64” is displayed with DTC “U1000–01” or “C1A04–97”, first diagnose the DTC “U1000–01” or “C1A04–97”...
Nissan Murano (Z52) 2015-2024 Service Manual: U1010-49 Control Unit(can)
DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Intelligent Forward Collision Warning (I-FCW)
- Turning the AEB system on/off
- Indicator lights
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
