Nissan Murano: Body Side Trim / Center Pillar Lower Finisher
Removal and Installation
REMOVAL
Move front seat to full forward position.
Remove front kicking plate. Refer to Removal and Installation - Front Kicking Plate.
Remove rear kicking plate. Refer to Removal and Installation - Rear Kicking Plate.
Release center pillar lower finisher clips and pawls using a suitable tool and remove.

 |
: Metal clip |
 |
: Clip |
 |
: Front |
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Visually check clips and pawls for deformation and damage during installation. Replace with new ones if necessary.
-
When installing center pillar lower finisher, check that clips are securely placed in body panel holes.
Removal and Installation
REMOVALRemove center pillar lower finisher. Refer to Removal and Installation.
Release pawls, using a suitable tool (A) and remove seat belt height adjuster bolt cover (LH)...
Removal and Installation - Front Door Welt
REMOVALRemove center pillar upper finisher. Refer to Removal and Installation.
Remove front body side welt.INSTALLATIONInstallation is in the reverse order of removal...
Other information:
Removal and Installation
REMOVALRemove luggage side upper finisher bolt (A).
Using a suitable tool release pawls and remove second row seat belt d-ring finisher.
Remove second row seat belt d-ring anchor bolt and remove second row seat belt d-ring.
Using a suitable tool release clips, disconnect the harness connector (LH) and remove the luggage side upper finisher...
DTC Description
DTC DETECTION LOGICAn excessively low or high voltage signal is sent to ECM through the VIAS control solenoid valve 1. DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P1800
VIAS S/V CIRC-B1
(VIAS solenoid valve circuit bank 1)
Diagnosis condition
Start engine and let it idle
Signal (terminal)
VIAS control solenoid valve 1 signal
Threshold
An excessively low or high voltage signal is sent to ECM
Diagnosis delay time
—
POSSIBLE CAUSE
Harness or connectors
(Input speed sensor circuit is open or shorted)
VIAS control solenoid valve 1
FAIL-SAFENot applicable
DTC Confirmation Procedure
CONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test...
Categories

The autolight system allows the headlights
to turn on and off automatically. The autolight
system can:
Turn on the headlights, front parking,
tail, license plate and instrument panel
lights automatically when it is dark.
Turn off all the lights (except daylight
running lights) when it is light.
Keep all the lights on for a period of time
after you place the ignition switch in the
OFF position and all doors are closed.
read more