Nissan Murano: Brake System :: Periodic Maintenance / Brake Pedal
BRAKE PEDAL HEIGHT
Remove instrument lower panel LH. Refer to Removal and Installation.
Disconnect the harness connectors from the stop lamp switch and brake pedal position switch.
Turn the stop lamp switch and brake pedal position switch 45° counterclockwise.
Loosen the input rod lock nut (1).
CAUTION:
-
Check the height with the floor trim removed.
-
The threaded end of the input rod (2) must project to the inner side (L) of the clevis (3).
Adjust the brake pedal height to the specification. Refer to Brake Pedal.
Tighten the input rod lock nut to specification. Refer to Exploded View.
Turn the stop lamp switch and brake pedal position switch 45° clockwise.
Connect the harness connectors to the stop lamp switch and brake pedal position switch.
Check the brake pedal for smooth operation.
CAUTION:
The stop lamp must turn off when the brake pedal is released.
Install instrument lower panel LH. Refer to Removal and Installation.
STOP LAMP SWITCH AND BRAKE PEDAL POSITION SWITCH
Remove instrument lower panel LH. Refer to Removal and Installation.
Disconnect the harness connectors from the stop lamp switch and brake pedal position switch.
Turn the stop lamp switch and brake pedal position switch 45° counterclockwise.
With the threaded ends of the stop lamp switch (1) and brake pedal position switch (2) contacting the pedal bracket (3), turn the switches 45° clockwise to lock in place. Check that both the stop lamp switch (1) and brake pedal position switch (2) contact ends to brake pedal bracket (3) clearance (A) are within specification.
CAUTION:
-
Make sure that the clearance (A) between the brake pedal bracket (3), stop lamp switch (1) and the brake pedal position switch (2) contact ends are within specification.
-
The stop lamp must turn off when the brake pedal is released.
| Clearance (A) | : Refer to Brake Pedal. |
Connect the harness connector to the stop lamp switch and the brake pedal position switch.
Install instrument lower panel LH. Refer to Removal and Installation.
Brake Fluid
Drain and Refill
CAUTION:
Do not spill or splash brake fluid on painted surfaces. Brake fluid may damage paint. If brake fluid is splashed on painted areas, wash it away with water immediately...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: B2560 Starter Cont Relay
DTC Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N (Neutral) or P (Park) position.DTC DETECTION LOGICNOTE: If DTC B2560 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000...
Nissan Murano (Z52) 2015-2024 Service Manual: Remote Keyless Entry Function
System Description SYSTEM DIAGRAMSYSTEM DESCRIPTIONThe Intelligent Key has the same functions as the remote control entry system. Therefore, it can be used in the same manner as the remote controller by operating the door lock/unlock button.INPUT SIGNAL AND OUTPUT SIGNAL Signal name Input Output Description Key ID signal Remote keyless entry receiver BCM The BCM receives key ID signal inputs and activates the actuators accordingly...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Checking engine oil level
- Power Steering Fluid (PSF)
- Passenger compartment
- New on site
- Most important about car
Seatback pockets
Theremaybe one or two seatback pockets located on the back of the driver and passenger seats. The pockets can be used to store maps.
WARNING
