Nissan Murano: Dtc/circuit Diagnosis / B1321 Front Right Tweeter

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Navigation Without Bose / Dtc/circuit Diagnosis / B1321 Front Right Tweeter

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B1321–13

Front right tweeter

(Instrument panel tweeter RH)
[OPEN] Diagnosis condition When ignition switch is ON.
Signal (terminal)
  • FR SP RH+ (terminal 11)

  • FR SP RH− (terminal 12)

Threshold
Diagnosis delay time 30 seconds or more

POSSIBLE CAUSE

  • FR SP RH+ open

  • FR SP RH− open

  • Instrument panel tweeter

    RH
  • AV control unit

FAIL-SAFE

Instrument panel tweeter RH inoperative

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Ignition switch OFF and wait at least 30 seconds.

  3. Ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “MULTI AV”.

  5. Check DTC.

Is DTC B1321–13 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK SOUND SIGNAL CIRCUITS FOR OPEN

  1. Ignition switch OFF.

  2. Disconnect AV control unit connector and instrument panel tweeter RH connector.

  3. Check the continuity between AV control unit connector and instrument panel tweeter RH connector .

    AV control unit Instrument panel tweeter RH Continuity
    Connector Terminal Connector Terminal
    M161 11 M74 1 Yes
    12 2

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness or connectors.

CHECK INSTRUMENT PANEL TWEETER RH SIGNAL

  1. Connect AV control unit connector and instrument panel tweeter RH connector.

  2. Ignition switch ON.

  3. AV control unit ON.

  4. Check signal between the terminals of AV control unit connector.

    AV control unit Condition Reference value
    Connector (+) (−)
    Terminal
    M161 11 12 Audio signal output

Is the inspection result normal?

YES>>

Replace instrument panel tweeter RH. Refer to Removal and Installation.

NO>>

Replace AV control unit. Refer to Removal and Installation.

    B1315 Am/fm 1 Antenna

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1315–13 AM/FM 1 antenna (Radio antenna) [OPEN] Diagnosis condition When ignition switch is ON...

    B1328 External Microphone 1

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1328–13 External Microphone 1 (Microphone) [OPEN] Diagnosis condition When ignition switch is ON...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: P1800 Vias Control Solenoid Valve 1


    DTC Description DTC DETECTION LOGICAn excessively low or high voltage signal is sent to ECM through the VIAS control solenoid valve 1. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1800 VIAS S/V CIRC-B1 (VIAS solenoid valve circuit bank 1) Diagnosis condition Start engine and let it idle Signal (terminal) VIAS control solenoid valve 1 signal Threshold An excessively low or high voltage signal is sent to ECM Diagnosis delay time — POSSIBLE CAUSE Harness or connectors (Input speed sensor circuit is open or shorted) VIAS control solenoid valve 1 FAIL-SAFENot applicable DTC Confirmation Procedure CONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test...

    Nissan Murano (Z52) 2015-2024 Service Manual: P2758 Tcc Pressure Control Solenoid


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2758 TCC PRESSURE CONT SOLENOID (Torque Converter Clutch Pressure Control Solenoid Control Circuit Stuck On) Diagnosis condition When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V Lockup value learning is completed (After ignition switch ON) Signal — Threshold Coast capacity learning value: Less than –0...

    Categories

    Vehicle security system

    Nissan Murano. Vehicle security system

    Your vehicle has two types of security systems:

    Vehicle security system NISSAN Vehicle Immobilizer System

    The vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.

    read more

     
    Copyright © 2026 www.nimurano.com