Nissan Murano: Removal and Installation / Around View Monitor Control Unit
Exploded View

| 1. |
Instrument panel assembly |
2. |
Around view monitor control unit |
|
|
Removal and Installation
REMOVAL
NOTE:
Before replacing around view monitor control unit, perform “Before Replace ECU” of “Read / Write Configuration” to save or print current Nissan Murano vehicle specification. Refer to Description.
Remove driver and passenger seat assembly. Refer to Removal and Installation.
Reposition driver and passenger seat away from center console.
Remove center console assembly. Refer to Removal and Installation.
Remove around view monitor control unit screws.
Disconnect the harness connectors from around view monitor control unit and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Be sure to perform “After Replace ECU” of “Read / Write Configuration” or “Manual Configuration” when replacing around view monitor control unit. Refer to Description.
-
Perform the calibration and perform the writing to the around view monitor control unit when removing and replacing each camera, removing the camera mounting parts (front grille, door mirror, etc.) and replacing the around view monitor control unit. Refer to Description.
NOTE:
Perform predictive course line center position adjustment. Refer to Description.
Exploded View
1.
Audio unit bracket (RH)
2.
Audio unit
3.
Audio unit bracket (LH)
4.
A/C auto amp.
Removal and Installation
REMOVALCAUTION:
Before disconnecting the audio unit and battery terminals, turn the ignition switch OFF and wait at least 30 seconds...
Removal and Installation
REMOVALRemove front grille. Refer to Removal and Installation.
Disconnect the harness connector from the front camera.
Remove screws (A) and remove front camera (1)...
Other information:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0053
HO2S1 HTR B1
(HO2S heater resistance bank 1 sensor 1)
Diagnosis condition
—
Signal (terminal)
A/F sensor 1 heater (bank 1) signal
Threshold
During engine running, weighted average of A/F sensor internal resistance is out of the normal range
Diagnosis delay time
—
POSSIBLE CAUSE
Harness and connectors [A/F sensor 1 (bank 1) heater circuit is open or shorted...