Nissan Murano: Changing engine oil and oil filter / After the operation
Nissan Murano (Z52) 2015-2024 Owners Manual / Do-it-yourself / Engine oil / Changing engine oil and oil filter / After the operation
- Reinstall engine protectors in reverse order of removal.
- Lower the vehicle carefully to the ground.
- Reset oil and oil filter maintenance reminder.
For additional information, refer
to “Vehicle information display” in
the “Instruments and controls” section
of this manual.
- Dispose of waste oil and filter properly.
- Check your local regulations.
Engine oil and filter
Place a large drain pan under the drain
plug and oil filter.
Remove the oil filler cap.
Remove the drain plug with a wrench
by turning it counterclockwise and
completely drain the oil...
Continuously Variable Transmission (CVT) fluid
CAUTION
NISSAN recommends using Genuine
NISSAN CVT Fluid NS-3 (or equivalent)
ONLY in NISSAN CVTs. Do not mix with
other fluids.
Do not use Automatic Transmission
Fluid (ATF) or manual transmission
fluid in a NISSAN CVT, as it may damage
the CVT...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Additional Service When Replacing Control Unit
Description AIR BAG DIAGNOSIS SENSOR UNITVehicle specifications are not yet written in a new air bag diagnosis sensor unit. It is therefore necessary to write the specifications to the new unit and then perform “Re/programming, Configuration” with CONSULT...
Nissan Murano (Z52) 2015-2024 Service Manual: Preparation. Preparation
..
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- Settings
- Passenger compartment
- New on site
- Most important about car
Copyright © 2026 www.nimurano.com