Nissan Murano: Basic Inspection / Accelerator Pedal Released Position Learning

Nissan Murano (Z52) 2015-2024 Service Manual / Engine / Engine Control System :: Vq35de / Basic Inspection / Accelerator Pedal Released Position Learning

Description

Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time the harness connector of the accelerator pedal position sensor or ECM is disconnected.

For details, refer to Work Procedure.

Work Procedure

START

Check that accelerator pedal is fully released.
Turn ignition switch ON and wait at least 2 seconds.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and wait at least 2 seconds.
Turn ignition switch OFF and wait at least 10 seconds.

END

Additional Service When Replacing Ecm

Description When replacing ECM, the following procedure must be performed. (For details, refer to Work Procedure.)CAUTION: When replacing the ECM, always replace it with a new one...

Throttle Valve Closed Position Learning

Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Abs Actuator and Electric Unit (control Unit)

Exploded View 1. ABS actuator and electric unit (control unit) 2. Bracket A. To rear (RH) brake caliper. Refer to Exploded View. B. From master cylinder secondary side. Refer to Exploded View. C. Refer to Removal and Installation. D...

Nissan Murano (Z52) 2015-2024 Service Manual: Engine Can Not Start

Diagnosis Procedure Engine does not start when ignition switch is pressed.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) OK OK No start No start CONDITIONS OF VEHICLE (OPERATING CONDITIONS)“ENGINE START BY I-KEY” setting in “Work support” mode of “BCM(INTELLIGENT KEY)” is ON...