Nissan Murano: Driver Assistance System :: Adas Control Unit / Removal and Installation. Adas Control Unit 2
REMOVAL
NOTE:
Before replacing ADAS control unit, perform “Before Replace ECU” of “Read / Write Configuration” to save or print current Nissan Murano vehicle specification. Refer to Description.
Remove the center console assembly. Refer to Removal and Installation.
Disconnect the harness connector from ADAS control unit
Release the pawl and remove the ADAS control unit (1) in the direction as shown 
.
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Be sure to perform “After Replace ECU” of “Read / Write Configuration” or “Manual Configuration” when replacing ADAS control unit. Refer to Description.
-
Be sure to perform “Configuration (ADAS control unit)” when replacing ADAS control unit. Refer to Description.
Power Supply and Ground Circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to Wiring Diagram.CHECK FUSES
Check that the following fuse is not blown:
Signal name Fuse No...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Additional Service When Replacing Control Unit
Description Each function is reset to the following condition when the driver seat control unit is replaced. Function Condition Procedure Memory (Seat, steering column, door mirror) Erased Perform storing Entry/exit assist ON Perform initialization Set slide amount*1 Linking a key fob to meter display Erased Perform initialization Perform storing *1: Default value is 40 mm...
Nissan Murano (Z52) 2015-2024 Service Manual: Service Data and Specifications (sds). Service Data and Specifications (sds)
Idle Speed Condition Specification No load* (in P or N position) 625 ± 50 rpm *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead position Ignition Timing Condition Specification No load* (in P or N position) 12 ± 2° BTDC *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead position Calculated Load Value Condition Specification (Using CONSULT or GST) At idle 10 – 35 % At 2,500 rpm 10 – 35 % Mass Air Flow Sensor Supply voltage Approx...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Turning the AEB system on/off
- Shift lock release
- Jacking up vehicle and removing the damaged tire
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
