Nissan Murano: Rear Axle :: Periodic Maintenance / Rear Drive Shaft
Inspection
Check the following items, and replace the parts as necessary.
Check drive shaft mounting points and drive shaft joint for looseness and other damage.
CAUTION:
Replace entire drive shaft when noise or vibration occurs from drive shaft.
Check boot for cracks and other damage.
On-vehicle Service
Check axle and suspension parts for excessive play, wear or damage.
Move the wheel as shown to check for excessive play.
Inspection
Check wheel hub bearing axial end play...
Other information:
Reference Value
TERMINAL LAYOUTPHYSICAL VALUES
Terminal No.
(wire color) Description Condition
Voltage
(Approx.)
+ - Signal name Input/Output
3
(Y/L)
Ground
Power window serial link
Input/Output
IGN SW ON or power window operating
4
(B)
Ground
Encoder ground
—
—
—
5
(L/W)
Ground
Encoder power supply
Output
When ignition switch ON or power window timer operates...
NISSAN recommends rotating the
tires every 5,000 miles (8,000 km).
For additional information on tire replacing
procedures, refer to “Flat tire”
in the “In case of emergency” section
of this manual.
As soon as possible, tighten the
wheel nuts to the specified torque
with a torque wrench...