Nissan Murano: Dtc/circuit Diagnosis / P1700 Cvt Control System

P159f Active Grille Shutter

DTC Description DTC DETECTION LOGICActive grille shutter normally stops within zone which is defined by zone (90°±20°).If the active grille shutter stops within zone stuck error is detected, and if the active grille shutter stops at position beyond zone overrun error is detected...

P1800 Vias Control Solenoid Valve 1

DTC Description DTC DETECTION LOGICAn excessively low or high voltage signal is sent to ECM through the VIAS control solenoid valve 1. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1800 VIAS S/V CIRC-B1 (VIAS solenoid valve circuit bank 1) Diagnosis condition Start engine and let it idle Signal (terminal) VIAS control solenoid valve 1 signal Threshold An excessively low or high voltage signal is sent to ECM Diagnosis delay time — POSSIBLE CAUSE Harness or connectors (Input speed sensor circuit is open or shorted) VIAS control solenoid valve 1 FAIL-SAFENot applicable DTC Confirmation Procedure CONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B2600-46 Config Error

DTC Description DTC DETECTION LOGIC DTC Trouble diagnosis (Trouble diagnosis contents) Detecting condition B2600-46 CONFIG ERROR (Configuration error) [CALIB/PRMTER MEMORY ERROR] When errors are detected in the configuration data stored in the 3CH CAN gateway...

Nissan Murano (Z52) 2015-2024 Owners Manual: Heated steering wheel switch (if so equipped)

The heated steering wheel system is designed to operate only when the surface temperature of the steering wheel is below 68°F (20°C). Push the heated steering wheel switch to warm the steering wheel after the ignition switch is placed in the ON position...