Nissan Murano: Body Interior / Instrument Panel :: Preparation. Preparation

Instrument Panel :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Instrument Panel :: Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses

Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to Diagnostic Worksheet...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0112 Iat Sensor

DTC Description DTC DETECTION LOGIC An excessively low voltage from the sensor is sent to ECM. An excessively high voltage from the sensor is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0112 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit low bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively low voltage from the sensor is sent to ECM Diagnosis delay time — P0113 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit high bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively high voltage from the sensor is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0112 Harness and connectors (The sensor circuit is open or shorted...

Nissan Murano (Z52) 2015-2024 Service Manual: Front Wiper Stop Position Signal Circuit

Component Function Check CHECK FRONT WIPER STOP POSITION SIGNAL CONSULT Select “WIP AUTO STOP” in “Data Monitor” mode of “IPDM E/R”. Operate the front wiper. Check that the function operates normally according to the following conditions: Monitor item Condition Monitor status WIP AUTO STOP Front wiper motor Stop position STOP P Except stop position ACT P Is the inspection result normal? YES>> Front wiper stop position signal circuit is normal...