Nissan Murano: Engine Maintenance (vq35de) / Fuel Lines

Engine Coolant

System Inspection WARNING: Do not remove the radiator cap or reservoir tank cap when the engine is hot. Serious burns could occur from high-pressure engine coolant escaping from the cooling system...

Engine Oil

Inspection ENGINE OIL LEVELNOTE: Before starting the engine, check the engine oil level. If the engine is already started, stop it and allow 10 minutes before checking...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Ecu Diagnosis Information. Adas Control Unit 2

Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item Condition Value/Status MAIN SW Ignition switch ON When MAIN switch is pressed On When MAIN switch is not pressed Off SET/COAST SW Ignition switch ON When SET/COAST switch is pressed On When SET/COAST switch is not pressed Off CANCEL SW Ignition switch ON When CANCEL switch is pressed On When CANCEL switch is not pressed Off RESUME/ACC SW Ignition switch ON When RESUME/ACCELERATE switch is pressed On When RESUME/ACCELERATE switch is not pressed Off DISTANCE SW Ignition switch ON When DISTANCE switch is pressed On When DISTANCE switch is not pressed Off CRUISE OPE Drive the Nissan Murano vehicle and activate the vehicle-to-vehicle distance control mode When ICC system is controlling On When ICC system is not controlling Off BRAKE SW Ignition switch ON When brake pedal is depressed Off When brake pedal is not depressed On STOP LAMP SW Ignition switch ON When brake pedal is depressed On When brake pedal is not depressed Off IDLE SW Engine running Idling On Except idling (depress accelerator pedal) Off VHCL SPEED SE While driving Displays the Nissan Murano vehicle speed calculated by ADAS control unit ENGINE RPM Engine running Equivalent to tachometer reading THRTL SENSOR NOTE: The item is displayed, but it is not used...

Nissan Murano (Z52) 2015-2024 Service Manual: Checking Damage

Checking Damage When completing body and frame repairs, the front body and underbody dimensions must be correct, because these dimensions directly affect wheel alignment and steering angles.The degree of damage should be determined by using a steel tape, tram tracking gauge and centering gauge or other measuring device...