Nissan Murano: Road Wheels & Tires :: Basic Inspection / Diagnosis and Repair Work Flow

Work Flow

NOTE:

The Signal Tech II Tool [– (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

COLLECT INFORMATION FROM CUSTOMER

Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred).

GO TO 2.

TIRE AND WHEEL INSPECTION

Check all tires and wheels for physical damage. Refer to Inspection.

Is the inspection result normal?

GO TO 3.

Repair or replace as necessary.

TIRE PRESSURE INSPECTION

Check the tire pressure for all wheels. Refer to Tire Air Pressure.

Is the inspection result normal?

GO TO 4.

Check tire(s), wheel(s) and valve stem(s) for air leaks. Repair or replace as necessary.

CHECK LOW TIRE PRESSURE WARNING LAMP

Check that the low tire pressure warning lamp illuminates for approximately 1 second after placing the ignition switch ON, then OFF.

Does the low tire pressure warning lamp turn OFF?

Inspection End.

GO TO 5.

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

Select “Self Diagnostic Result” mode of "BCM(AIR PRESSURE MONITOR)". Refer to Diagnosis Description.

Are any DTCs displayed?

Refer to DTC Index. If two or more DTCs are displayed, refer to DTC Inspection Priority Chart.

GO TO 6.

PERFORM DIAGNOSIS APPLICABLE TO THE SYMPTOM

Perform diagnosis applicable to the symptom. Refer to Symptom Table.

GO TO 7.

FINAL CHECK

CONSULT

Select “Self Diagnostic Result” mode of "BCM(AIR PRESSURE MONITOR)" again, and check that the malfunction is repaired. After checking, erase the self diagnosis memory. Refer to Diagnosis Description.

Inspection End.