Nissan Murano: Charging System :: System Description / Component Parts. Charging System

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Charging System :: System Description / Component Parts. Charging System

Component Parts Location

Engine room left side

Combination meter

No.	Component	Description
1.	Generator (IC regulator)	Refer to Generator.
2.	Combination meter (charge warning lamp)	The IC regulator warning function activates to illuminate the charge warning lamp if any of the following symptoms occur while generator is operating: ·Excessive voltage is produced. ·No voltage is produced. Refer to Component Parts Location for detailed component location.

No.

Component

Description

Generator (IC regulator)

Refer to Generator.

Combination meter (charge warning lamp)

The IC regulator warning function activates to illuminate the charge warning lamp if any of the following symptoms occur while generator is operating:

·Excessive voltage is produced.

·No voltage is produced.

Refer to Component Parts Location for detailed component location.

Generator

The generator is located at lower RH side of engine compartment
The IC regulator controls the power generation voltage by the target power generation voltage based on the received power generation command signal. When there is no power generation command signal, the generator performs the normal power generation according to the characteristic of the IC voltage regulator.

Charging System :: System Description

System. Charging System

System Description SYSTEM DIAGRAMSignal transmission function list Component Signal Combination meter Charge warning lamp signal System DescriptionThe generator provides DC voltage to operate the vehicle's electrical system and to keep the battery charged...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Exterior :: Preparation. Preparation

Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) NISSAN Squeak and Rattle Kit Repairing the cause of noise — (J-46534) Trim Tool Set Removing trim components Commercial Service Tools (TechMate No...

Nissan Murano (Z52) 2015-2024 Service Manual: Ecu Diagnosis Information. Awd Control Unit

Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle: For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item Condition Value/Status STOP LAMP SW Brake pedal: Depressed On Brake pedal: Released Off ENG SPEED SIG Engine stopped (Engine speed: Less than 400 rpm) Stop Engine running (Engine speed: 400 rpm or more) Run ETS ACTUATOR Engine stopped (Ignition switch: ON) Off Engine running On 4WD WARN LAMP AWD warning icon/display: ON On AWD warning icon/display: OFF Off 4WD MODE SW Always AUTO 4WD MODE MON Always AUTO DIS-TIRE MONI Nissan Murano Vehicle running with normal size tire installed 0 – 4 mm Nissan Murano Vehicle running with improper size tire installed (Front/rear tire size difference, wear condition) 4 – 8 mm, 8 – mm P BRAKE SW Parking brake operated On Parking brake not operated Off BATTERY VOLT Always Battery voltage THRTL POS SEN When depressing accelerator pedal (Value rises gradually in response to throttle position...