Nissan Murano: Electrical & Power Control / Charging System :: Preparation. Preparation
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
|
Tool number
(TechMate No.)
Tool name | | Description |
|
165-GR8-1200KIT
(—)
Midtronics Battery Charger and Tester |

|
Tests batteries, starting and charging systems and charges batteries.
For operating instructions, refer to diagnostic station instruction manual. |
|
165–DSS-5000P
(—)
Midtronics Hand–Held Battery Tester |

|
Tests batteries, starting and charging systems.
For operating instructions, refer to diagnostic analyzer instruction manual. |
Commercial Service Tool
| Tool name | | Description |
| Power tool |

|
Loosening nuts, screws and bolts |
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
C1602
NO TUNING SET
(No tuning set)
Diagnosis condition
When ignition switch ON.
Signal (terminal)
—
Threshold
Information in power steering module is not the same
Diagnosis delay time
—
POSSIBLE CAUSE
Harness or connector
Power steering control module
Battery power supply circuit
Ignition power supply circuit
Battery
Fuse
Ground circuit
FAIL-SAFEManual steering state
DTC Confirmation Procedure
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...
Exploded View
FWD Models 1.
Gusset
2.
Transaxle assembly
3.
O-ring
4.
CVT fluid charging pipe
5.
Water outlet
6.
CVT fluid charging pipe cap
A.
For the tightening torque, refer to Removal and Installation .
: Apply petroleum jelly
AWD Models 1...