Nissan Murano: Mirrors :: Symptom Diagnosis / Auto Anti-Dazzling Inside Mirror Does Not Operate
Diagnosis Procedure
CHECK AUTO-ANTI DAZZLING INSIDE MIRROR SYSTEM
Check auto anti-dazzling inside mirror system.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
REPLACE GLASS MIRROR
-
Replace glass mirror. Refer to Removal and Installation.
-
Confirm the operation after replacement.
Is the result normal?
YES>>
Inspection End.
NO>>
Check intermittent incident. Refer to Intermittent Incident.
Work Flow
CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to Diagnostic Worksheet...
Other information:
In order to maintain the appearance of
your vehicle, it is important to take proper
care of it.
To protect the paint surfaces, wash your
vehicle as soon as you can:
After a rainfall to prevent possible damage
from acid rain.
After driving on coastal roads...
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detecting condition
B2416–1B
TOUCH SEN R OPEN
(Touch sensor right open)
Diagnosis condition
All times
Signal (terminal)
Touch sensor RH signal (automatic back door control module connector terminal: 4)
Threshold
When one of the following conditions is satisfied
Touch sensor RH circuit is open
Disconnect touch sensor RH connector
Diagnosis delay time
–
B2416–1E
TOUCH SEN R OPEN
(Touch sensor right open)
Diagnosis condition
All times
Signal (terminal)
Touch sensor RH signal (automatic back door control module connector terminal: 4)
Threshold
When one of the following conditions is satisfied
Touch sensor RH circuit is open
Disconnect touch sensor RH connector
Diagnosis delay time
–
POSSIBLE CAUSE
Improper installation of touch sensor
Touch sensor RH
Harness or connectors (touch sensor circuit is open)
Automatic back door control module
FAIL-SAFEInhibit automatic back door system auto open/close function
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...