Nissan Murano: Dtc/circuit Diagnosis / Ascd Indicator
CHECK ASCD INDICATOR FUNCTION
Check ASCD indicator under the following conditions.
| ASCD INDICATOR | CONDITION | SPECIFICATION | |
|---|---|---|---|
| CRUISE |
|
|
ON → OFF |
Is the inspection result normal?
YES>>INSPECTION END
NO>>Proceed to Diagnosis Procedure.
CHECK DTC
Check that DTC UXXXX is not displayed.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Perform trouble diagnosis for DTC UXXXX.
CHECK COMBINATION METER FUNCTION
Check combination meter function. Refer to CONSULT Function (METER/MA).
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace malfunctioning part.
CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to Intermittent Incident.
Is the inspection result normal?
YES>>Replace combination meter. Refer to Removal and Installation.
NO>>Repair or replace error-detected parts.
P2610 Ecm Internal Timer
DTC Description
DESCRIPTIONThis ECM contains a timer and measures time between an ignition switch OFF and the next ignition switch ON. This enables the judging of the state of engine cooling at an engine start...
Brake Pedal Position Switch
Component Function Check
CHECK BRAKE PEDAL POSITION SWITCH FUNCTION
With CONSULT
Turn ignition switch ON.
Select “BRAKE SW1” in “DATA MONITOR” mode with CONSULT...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Led Headlamp Operation Inspection
Work Procedure CHECK START In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp several times. Check that headlamp operates normally each time. In the cool LED status, turn headlamp ON, wait until headlamp enters the stable status (approximately 5 minutes after turning headlamp ON) and then check that headlamp operates normally without blinking or flickering...
Nissan Murano (Z52) 2015-2024 Service Manual: Hazard Switch Circuit
Component Function Check CHECK HAZARD SWITCH SIGNAL CONSULT Ignition switch ON. Select “HAZARD SW” in “Data Monitor” mode of “BCM(FLASHER)”. While operating the hazard switch, check the monitor status. Monitor item Condition Monitor status HAZARD SW Hazard switch ON On OFF Off Is the inspection result normal? YES>> Hazard switch circuit is normal...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Settings
- Memory storage function (key-link)
- GAS STATION INFORMATION
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
