Nissan Murano: Road Wheels & Tires :: Ecu Diagnosis Information / Air Pressure Monitor
CAUTION:
The reference values in the table below come from the control unit calculation data. The normal values may in some cases be displayed even though the power circuit (harness) is open or shorted.
NOTE:
The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
| Monitor item | Data monitor | |
|---|---|---|
| Condition | Reference values for normal operation | |
| AIR PRESS FL |
|
Tire pressure (psi), (kPa) or (kgf/cm2) |
| AIR PRESS FR | ||
| AIR PRESS RR | ||
| AIR PRESS RL | ||
| WARNING AIR PRESSURE FL | Ignition switch ON | Indicates warning air pressure front left tire (psi), (kPa) or (kgf/cm2) |
| WARNING AIR PRESSURE FR | Ignition switch ON | Indicates warning air pressure front right tire (psi), (kPa) or (kgf/cm2) |
| WARNING AIR PRESSURE RR | Ignition switch ON | Indicates warning air pressure rear right tire (psi), (kPa) or (kgf/cm2) |
| WARNING AIR PRESSURE RL | Ignition switch ON | Indicates warning air pressure rear left tire (psi), (kPa) or (kgf/cm2) |
| VHCL SPEED SE | Drive the Nissan Murano vehicle. | Vehicle speed (MPH) or (km/h) |
| LOW TIRE PRESSURE W/L | Ignition switch ON |
Low tire pressure warning lamp ON: On Low tire pressure warning lamp OFF: Off |
| BUZZER 2 | Ignition switch ON |
Combination meter buzzer ON: On Combination meter buzzer OFF: Off |
| HORN | Ignition switch ON |
Horn ON: On Horn OFF: Off |
| HAZARD | Ignition switch ON |
Hazard lamp ON: On Hazard lamp OFF: Off |
Bcm
L..
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Ground
Ground Distribution BACK DOOR HARNESSRefer to Wiring Diagram.BODY HARNESSRefer to Wiring Diagram.BODY NO. 2 HARNESSRefer to Wiring Diagram.ENGINE ROOM HARNESSRefer to Wiring Diagram.FRONT END MODULE HARNESSRefer to Wiring Diagram.ENGINE CONTROL HARNESSRefer to Wiring Diagram...
Nissan Murano (Z52) 2015-2024 Service Manual: Exterior :: Preparation. Preparation
Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) NISSAN Squeak and Rattle Kit Repairing the cause of noise — (J-46534) Trim Tool Set Removing trim components Commercial Service Tools (TechMate No...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Indicator lights
- How to enable/disable the LDW system
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
