Nissan Murano: Lan System :: Can Fundamental / Precaution. Precautions
CAUTION:
Follow the instructions listed below. Failure to do this may cause damage to parts:
-
Never apply 7.0 V or more to the measurement terminal.
-
Use a tester with open terminal voltage of 7.0 V or less.
-
Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when checking the harness.
-
Solder the repaired area and wrap tape around the soldered area.
NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).
-
Bypass connection is never allowed at the repaired area.
NOTE:
Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
-
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.
How to Use This Manual. How to Use This Section
Information
“CAN FUNDAMENTAL” of LAN Section describes the basic knowledge of the CAN communication system and the method of trouble diagnosis.
For information peculiar to a Nissan Murano vehicle and inspection procedure, refer to “CAN”...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Intake Manifold
Exploded View 1. Intake manifold 2. Intake manifold gasket A. Refer to Removal and Installation. Removal and Installation REMOVALWARNING: To avoid the danger of being scalded, do not drain the coolant when the engine is hot. NOTE: When removing components such as hoses, tubes/lines, etc...
Nissan Murano (Z52) 2015-2024 Service Manual: Hood Lock Release Handle
Removal and Installation REMOVALRemove fuel filler lid/hood lock release handle bolts (A). Disconnect fuel filler lid release cable (2) from fuel filler lid release handle (1). Disconnect hood lock release cable (4) from hood lock release handle (3)...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- GAS STATION INFORMATION
- Checking engine oil level
- Intelligent Forward Collision Warning (I-FCW)
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
