Nissan Murano: Ventilation, Heater & Air Conditioner / Heater & Air Conditioning System :: Service Data and Specifications (sds). Service Data and Specifications (sds)
Compressor
| Type |
Variable displacement swash plate |
| Displacement |
|
175 cm3 (10.7 cu in)/rev |
| Number of cylinders |
10 |
| Cylinder bore diameter × stroke |
30.5 x 24 mm (1.2 x 0.9 in) |
| Direction of rotation |
Clockwise (viewed from clutch) |
| Drive belt |
Poly V 7 grooves |
| Disc to pulley clearance |
Standard |
0.3 – 0.6 mm (0.012 – 0.024 in) |
Oil
| Name |
A/C System Oil Type ND-OIL12 (PAG) |
|
Capacity
m (US fl oz, lmp fl oz) |
Total in system |
100 (3.4, 3.5) |
| Compressor (service part) charging amount |
Refer to Oil Adjusting Procedure for Compressor Replacement. |
Refrigerant
| Type |
HFO-1234yf (R-1234yf) |
| Capacity |
0.575 ± 0.05 kg (1.268 ± 0.1102 lb) |
Removal and Installation
Heating and Cooling Unit Assembly Components 1.
Heating and cooling unit assembly
2.
Evaporator
3.
Heater case side cover
4...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Other information:
Exploded View
1.
Center exhaust tube
2.
Front exhaust tube
3.
Ring gasket
4.
Front exhaust tube bracket
5.
Gasket
6.
Mounting rubber
7.
Mounting rubber
8.
Mounting rubber
9.
Gasket
10.
Muffler
Front
Removal and Installation
WARNING:
Perform the procedure with the exhaust system fully cooled down because the system will be hot just after the engine is turned off...
Removal and Installation
CAUTION:
Use care not to bend touch sensor.
Replace the back door touch sensor if it has been dropped or sustained an impact.
REMOVALRelease touch sensor clips using a suitable tool.
Disconnect the harness connector from the touch sensor and remove...